I recall someone, somewhere doing this but for the life of me can' recall who.
Reason is that I'm thinking of doing it for the remaining internal doors as several of those already made, the stiles are bending out of straight big time
3/8"at the bottom on one of them.
AFAIK I thicknessed evenly off both sides. Measured the moisture content of the remaining timber in the workshop at 8% (OK I know it's a cheap meter and so not that accurate). But I was interested in a comparison with the doors inside and that is 4%...so half as much....regardless of actual value.
Reason is that I'm thinking of doing it for the remaining internal doors as several of those already made, the stiles are bending out of straight big time
3/8"at the bottom on one of them.AFAIK I thicknessed evenly off both sides. Measured the moisture content of the remaining timber in the workshop at 8% (OK I know it's a cheap meter and so not that accurate). But I was interested in a comparison with the doors inside and that is 4%...so half as much....regardless of actual value.
